Dublin Draught Stout Clone 4.2% ABV Extract
€17.96
Dublin Draught Stout Clone 4.2% ABV Extract
An excellent clone of the world's best known "classic" Irish stout
IBU: 30An excellent clone of the world's best known "classic" Irish stout
EBC: 80
Target Original Gravity: 1.038
Target Final Gravity: 1.006
Target ABV: 4.2%
Ingredients:
- malted barley (1.32 Kg)
- malt extract (1.64 Kg)
- hop pellets (48 grams approx), adjusted for alpha values
- dried brewing yeast (Ale)
- priming sugar (131 grams dextrose)
Allergen Declaration: Cereals Containing Gluten
Instructions:
Please read all the instructions, including the Notes below, before starting your brew.
- heat 4.5 litres of water to 72 oC
- crush grains and add to water (in nylon bag, see notes below) along with the flaked barley
- steep grains at 66 oC for 45 miunutes
- while grains are steeping, heat 8.3 litres of water in your brewing kettle
- when steep is finished, take 1.25 litres of hot water from the brewing kettle and add to the grains
- place the grain bag in a colander
- then place the colander over the brewing kettle and pour the grain tea through the grain bag to strain out any solids and to rinse any remaining sugars from the grains
- bring the water in the brewing kettle to the boil and gently stir in the dried malt extract powder
- add hop pack A and boil for 60 minutes
- 15 minutes from the end of the boil, turn off the heat and stir in the contents of the liquid malt extract sachet
- stir well to dissolve all of the extract and then turn the heat back on to resume boiling (keep the boil timer running)
- at the end of the boil, cool wort and transfer to fermenter
- add water to make it up to 20 litres
- aerate wort and pitch yeast
- ferment at 20 oC
- rack to secondary when fermentation is complete
- bottle when beer clears
Note 1: Hops should be placed in our small fine mesh nylon drawstring bags and then added to the wort.
Note 2: Steeping grains should be placed in our medium fine mesh nylon drawstring bag and then added to the water.
Note 3: After cooling the wort, remove the hop bags and and stir the wort vigorously in a circular motion for a minute to create a whirlpool (this will cause any particles to gather in the centre of the boiler). Wait a few minutes until the whirlpool stops and then gently transfer the wort into your fermenter, avoiding the remaining hops if possible. Its good to splash it about as it goes into the fermenter since adding air (oxygen) at this stage is good for the yeast.
Product Code:
1502170002